Chemistry Olympiad Kinetics: Reaching One-Eighth Takes Three Half-Lives

推荐

A half-life describes a proportional change, not a fixed amount removed on every occasion. This original chemistry exercise for Canadian Chemistry Olympiad readers compares a stated first-order model with a tempting straight-line calculation. The numerical data are hypothetical and are not taken from a contest paper.

Need help choosing a next step? Scan the contact QR code below or contact Hanlin on WeChat. Send CCO-EN-FIRST-ORDER-FRACTION-HALF-LIFE-1119 and tell us your school year and question.

Read the model before using the data

Suppose a reactant follows first-order decay under constant conditions. Its concentration falls from 0.800 mol/L to 0.400 mol/L in 12 minutes. For a first-order process the half-life is independent of the current concentration, so this interval establishes a half-life of 12 minutes. The statement that the process is first order matters: observing just one halving would not by itself prove the reaction order for every later concentration.

Track equal time intervals

After 12 minutes the concentration is 0.400 mol/L. After 24 minutes it is 0.200, and after 36 minutes it is 0.100. The target 0.100/0.800=1/8 equals (1/2) cubed, so three half-lives are required. Each interval halves what remains. The successive decreases are 0.400, 0.200 and 0.100 mol/L; they are not equal absolute decreases.

Check with the integrated law

Write [A]=[A]0 exp(-kt). The rate constant is ln(2)/12, approximately 0.05776 per minute. Setting [A]/[A]0=1/8 gives t=ln(8)/k=36 minutes. Units are important: using seconds with a rate constant expressed per minute introduces a factor of sixty. The ratio inside the logarithm is dimensionless, even though each concentration is measured in mol/L.

See why a linear extrapolation fails

Subtracting 0.400 mol/L every 12 minutes would predict zero after 24 minutes and a negative concentration later. That calculation treats the loss as constant in amount, which is a different kinetic model. For the ideal first-order law, concentration approaches zero without reaching it at a finite time. In an experiment, a reading below the detection limit is not proof of mathematically exact zero concentration.

Separate calculation from experimental evidence

To test a reaction-order proposal, examine data across an appropriate concentration range and control conditions that affect k. A first-order plot of ln[A] against time should be linear within the limitations of the measurements and model. As an extension, start at 0.600 mol/L with the same k and find the time to reach 0.150: two half-lives give 24 minutes. Record which assumption makes the original half-life reusable rather than memorising a single sequence of concentrations.

Continue reading: Canadian Chemistry Olympiad Practice: Doubling Concentration Does Not Always Double the Rate.

Contact Hanlin

Planning a first attempt or reviewing a topic you find difficult? Scan the QR code and send CCO-EN-FIRST-ORDER-FRACTION-HALF-LIFE-1119. Include your school year, country or competition region, experience and the question you want to discuss.

Scan to contact Hanlin on WeChat. Send CCO-EN-FIRST-ORDER-FRACTION-HALF-LIFE-1119.

Contact Hanlin on WeChat

On your phone, use the button or save the QR image and scan it within WeChat.

Official information and further reading: Source 1 Source 2

推荐
Online Customer Service
Contact Customer Service