A collected gas volume can contain both the intended gas and water vapour. Using the total pressure for the dry component would then overestimate its amount. This original calculation keeps the pressure definition explicit; it is not an experimental procedure, an official CCO question or a table of newly measured vapour pressures.
Need help choosing a next step? Scan the contact QR code below or contact Hanlin on WeChat. Send CCO-GAS-OVER-1117 and tell us your school year and question.
Specify the measured mixture
Suppose a hypothetical sample has total pressure 100.00 kilopascals and volume 0.500 litre at 293.15 kelvin. The only components are a dry gas and water vapour, and the problem gives the water-vapour partial pressure as 2.34 kilopascals. Assume ideal-gas behaviour. Treat 100.00 as the actual pressure of the mixture; if instead only atmospheric pressure were given with unequal liquid levels, a separate hydrostatic correction could be needed.
Use partial pressures before amounts
For the two-component ideal mixture, total pressure is the sum of component partial pressures. The dry-gas partial pressure is therefore 100.00 - 2.34 = 97.66 kilopascals. The subtraction changes which component is being counted, not the measured volume of the container. Both components occupy the mixture volume in this ideal description.
Apply a consistent gas constant
Use R = 8.314 kilopascal litres per mole per kelvin. The dry-gas amount is 97.66 times 0.500 divided by (8.314 times 293.15), approximately 0.0200 mole. Multiplying pressure in kilopascals by volume in litres works with this stated version of R. Using the litre value with a pascal-cubic-metre constant would require the appropriate unit conversion first.
Check the direction of the possible error
If 100.00 kilopascals were used instead, the computed amount would be about 0.0205 mole. It would include the water-vapour contribution as if all molecules belonged to the dry gas. The relative overestimate compared with the correct dry amount is 2.34/97.66, about 2.40 percent. This is a model comparison, not an uncertainty estimate for a real measurement.
Do not infer gas identity from this calculation
Pressure, temperature and volume determine an ideal amount, but they do not alone identify the chemical species or its molar mass. Additional components, dissolution or nonideal behaviour would also require further treatment. In a new problem, define the requested gas, identify every pressure contribution, establish the actual mixture pressure and only then convert the relevant partial pressure into an amount.
Continue reading: Canadian Chemistry Olympiad Practice: A Second Halving Need Not Take the Same Time.
Contact Hanlin
Planning a first attempt or reviewing a topic you find difficult? Scan the QR code and send CCO-GAS-OVER-1117. Include your school year, country or competition region, experience and the question you want to discuss.

On your phone, use the button or save the QR image and scan it within WeChat.

