For Canadian Chemistry Olympiad preparation, stoichiometry is more than substituting numbers into a ratio. You need to connect the balanced equation to the available amounts, identify what limits the reaction and state what your calculation assumes. A short original example can make those steps clear.
Need a clearer next step?
Tell us your school year, current topics and the question you want to work on. We can discuss a suitable preparation starting point.
Start with the balanced equation
Consider the theoretical reaction 2H₂ + O₂ → 2H₂O. Suppose 5 mol of H₂ and 2 mol of O₂ are available. Assume the reaction proceeds as written to completion, with no competing reactions. This is a paper calculation, not an experiment or an instruction to handle these substances.
The coefficients describe mole ratios: two moles of H₂ react with one mole of O₂ to form two moles of H₂O. They are not gram ratios. If a question gives masses, convert them to moles before comparing them using these coefficients.
Compare amounts relative to coefficients
Divide each available mole amount by its reactant coefficient. For H₂, 5/2 = 2.5. For O₂, 2/1 = 2. The smaller value identifies O₂ as the limiting reactant under the stated assumptions.
You can check this without the shortcut: reacting all 5 mol of H₂ would require 2.5 mol of O₂, but only 2 mol are available. There is not enough oxygen to use all the hydrogen.
Calculate the product and the excess
Using 2 mol of O₂ consumes 4 mol of H₂ and forms 4 mol of H₂O. The hydrogen remaining is 5 − 4 = 1 mol. There is no O₂ left in this idealised completion model.
The reactant with fewer moles is not always limiting. If the initial amounts were 3 mol of H₂ and 2 mol of O₂, the comparison would be 3/2 = 1.5 versus 2/1 = 2. Hydrogen would then be limiting, producing 3 mol of water and leaving 0.5 mol of oxygen.
Check atoms, mass and the meaning of yield
In the first example, the consumed reactants contain eight moles of hydrogen atoms and four moles of oxygen atoms. The 4 mol of water contain the same atom amounts. That is a useful consistency check.
The calculated 4 mol is a theoretical product amount under our assumptions. An actual recovered amount could differ because of incomplete conversion, side reactions or collection losses. If a question asks for percentage yield, use the specified actual amount divided by the theoretical amount, with matching units, then multiply by 100.
A practical review sequence
- Balance the equation before using any quantity.
- Label whether each amount is a mass, a mole amount or a concentration.
- Convert to moles where needed, keeping units visible.
- Determine the limiting reactant before calculating product.
- Check the remaining reactant and distinguish theoretical from actual yield.
When reviewing official public questions, write down the first incorrect assumption or conversion, not just the final wrong number. Repeating the calculation with changed initial amounts tests whether you understand the limiting condition.
CCC and CCO are related Canadian chemistry competitions with distinct requirements. Use the relevant official curriculum and public preparation materials, and confirm the rules for your location and event rather than treating every chemistry contest as interchangeable.
New to the subject? Read our Canadian Chemistry Olympiad Preparation: Where Should You Start?.
Official resources
- Chemical Institute of Canada: curriculum, data sheet and public past papers
- Canadian Chemistry Olympiad: official information
Contact Hanlin
Tell us your school year, current topics and the question you want to work on. We can discuss a suitable preparation starting point.
Scan the QR code below or use the WeChat contact link. Send CCO STOICHIOMETRY.


